Front Sway bar mount reinforcement kit for ND

Ships for free!
$129.00
Out of stock
Part number
13-39020
Don't rip your sway bars off your subframe.

ND Miatas can actually rip their sway bar mounts off the subframe under hard cornering with uprated sway bars. The fix is a new subframe. That's an expensive repair!

We worked with Paco Motorsports to bring this solution to market. They're a simple bolt-on upgrade with no drilling that will increase the strength of your sway bar mounts dramatically. Made of powdercoated steel and less than a pound of extra mass on the nose of the car, they're cheap insurance. Easy to install when you're doing a sway bar swap. Works with all sway bars that have at least 10mm clearance radially from the center of the lower stud holding the sway bar bracket - it would be unusual to have a fitment issue, but it's possible if you have an especially unique setup. 

More Information
Part number 13-39020
Fits model year: 2016 MX-5 soft top, 2017 MX-5 soft top, 2017 MX-5 RF, 2017 Fiat 124 Spider, 2018 MX-5 soft top, 2018 MX-5 RF, 2018 Fiat 124 Spider, 2019 MX-5 soft top, 2019 MX-5 RF
Fits Exocet? No
California emissions Emissions regulations do not apply
Manufacturer Paco Motorsports
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive No
Write Your Own Review
You're reviewing:Front Sway bar mount reinforcement kit for ND
Your Rating
© Flyin' Miata. All Rights Reserved.