Welcome to Flyin' Miata!

Flyin' Miata NA/NB dual hood lift kit

Flyin' Miata NA/NB dual hood lift kit
Flyin' Miata NA/NB dual hood lift kit
Rating
6 Review(s)

Availability: In stock

OR

Customer Reviews 6 item(s)

6 Item(s)

Worth the Money
For the most part they're easy to install. Getting the clip back on is trickiest part. Hood opens at a perfect speed and gets it higher than the hood prop did. Closing the hood is easy and once it gets to a certain point you can let the hood drop and close normal.
Rating
Review by Brian / (Posted on 11/9/2019)
Highly recommended
Great setup! Easy installation, the instructions are very clear and easy to follow. Product itself is very good quality and works exactly as intended.
Rating
Review by @metriciron / (Posted on 9/23/2019)
Awesome product; easy install for me
Installed these with the hood in the normal up position. Purchased the drill and tap. Made a couple of simple measurements per the instructions, drilled and tapped holes and then screwed in ball fittings. Popped the strut back on to the ball fittings. For me this was a fairly simple install. They work extremely well and provide excellent access to the engine components. Makes engine bay look very clean and got rid of the old hood rod!
Rating
Review by Charlie / (Posted on 4/15/2019)
They work but the install is painful.
These are not bolt-on. A drill and tap are required. Instructions are poorly illustrated, and poorly written, and they use the Queen's English, meaning that some translation will be required for anyone living in the states (hint for those of you who speak American English: "Wing" = "Fender").
Rating
Review by Mike / (Posted on 4/15/2018)
Great product
Great product, works really well. There were some clips in the bag and i'm honestly still not sure what they are used for because they weren't in the instructions.

i had no issues during installation, however, once you have both ball joints installed on my NA miata i had to pull the lift down to get both ends onto the ball joints. It was easier after i depressed them once on the ground before installation.
Rating
Review by Josh / (Posted on 4/15/2018)
Clean underhood look
I put these in about a week ago. Installation was actually a lot harder then I expected. It was a tight fit using a wrench to bolt the strut to the fender. Then with the hole drilled in the hood, I had to wrestle the top in and start the nut going while holding the strut under compression because the strut is still partially compressed when the hood is all the way open. I also had to unbolt the hood from the bracket so that I had room to thread the nut, which meant I had to unbolt and reposition the hood on the brackets again later to get the hood to close properly again. It was worth the trouble though. The engine bay feels more open without the prop rod and lends it a clean, uncluttered look. The hood lifts up gently and slowly and closes all the way on the first try just like stock. $70 well spent.
Rating
Review by Steven / (Posted on 12/12/2016)

Write Your Own Review

You're reviewing: Flyin' Miata NA/NB dual hood lift kit

How do you rate this product? *

 
1 1 star
2 2 star
3 3 star
4 4 star
5 5 star
Rating