Welcome to Flyin' Miata!

Polyurethane exhaust hanger (NB and NC chassis, extended length)

Shown with a standard length hanger for comparison
Polyurethane exhaust hanger (NB and NC chassis, extended length)
$9.79
Get your exhaust system under control and replace your droopy vintage rubber hangers.

Availability: In stock

Description

Details

Is your exhaust droopy? Do you have clanks and clunks under your car? The exhaust on your Miata is held up by 4-5 rubber hangers - and they're probably as old as your Miata. Make your exhaust all perky again with these polyurethane hangers. They're stiffer than the originals, so your exhaust will stay in place no matter how hard you drive. Great for cars with big exhausts and tight clearances. We think a lot of butterfly braces would fit better with a few of these.

This extended length one is approximately 1" longer than the original design. It works well to install a non-Mazdaspeed FM exhaust on a Mazdaspeed Miata.
 
Sold individually. Suitable for NB and NC. 4 needed on NB models, 5 for NC. 12mm holes.

Additional Information

Additional Information

Part number 06-97350 LONG
TÜV approval available No
Fits: No
Manufacturer No
Flyin' Miata exclusive No
Fits Exocet? No
Proposition 65 Warning: Cancer and reproductive harm
California emissions Emissions regulations do not apply
Reviews
Instructions
Instructions for this part are not currently available online.