USPS shipments from our warehouse may be slightly delayed. Details

Welcome to Flyin' Miata!

Polyurethane exhaust hanger (NA chassis)

Polyurethane exhaust hanger (NA chassis)
Polyurethane exhaust hanger (NA chassis)
Get your exhaust system under control and replace your droopy vintage rubber hangers.

Availability: In stock



Is your exhaust droopy? Do you have clanks and clunks under your car? The exhaust on your Miata is held up by 4 or 5 rubber hangers - and they're probably as old as your Miata. Make your exhaust all perky again with these polyurethane hangers. They're stiffer than the originals, so your exhaust will stay in place no matter how hard you drive. Great for cars with big exhausts and tight clearances. We think a lot of butterfly braces would fit better with a few of these.
 Sold individually. Factory exhausts use 5 hangers on the 1990-93 models and 4 on the 1994-97. Flyin' Miata exhausts use 4 for all 1990-97 cars. 10 mm holes 1.25" center to center, suitable for 1990-97 Miatas.

Additional Information

Additional Information

Part number 06-97345 STANDARD
Fits: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997
Manufacturer No
Flyin' Miata exclusive No
Fits Exocet? Yes
Proposition 65 Warning: Cancer and reproductive harm
California emissions Emissions regulations do not apply

Customer Reviews 3 item(s)

Good hangers, difficult to install.
Good, solid hangers but VERY difficult to install. Have some grease and maybe a heat gun handy. When I first installed the forward one on end of the muffler, it held the muffler too tight up to the car for me to get the rear one on. I had to take the front one back off (extremely difficult), then put both of them on the muffler first and line them up with their hangers on the car to get them both on. After I figured that out, the rest was fairly easy with some grease and extensive force. But all in all, my exhaust doesn’t rattle or droop anymore and I’m happy with them. Just hope I don’t have to take my exhaust off anytime soon.

Note from FM: This is true. They are very tenacious. We often use Simple Green as a lubricant to help with installation.
Review by Black1.8 / (Posted on 12/4/2019)
Very stiff bushings but unsuitable for my dual turbo catback.
Unfortunately the bushings were too short for my FM exhaust. With these mounted it would hit my rear bumper.
Review by JLo / (Posted on 5/21/2016)
No more droppy swingy exhausts EVER
These are great for upgraded larger exhaust systems or even replacement performance exhausts. Don't fool these with the other reinforced rubber hangers on the market...these are the quite possibly the best exhaust hangers available
Review by Roman / (Posted on 6/27/2015)
Instructions for this part are not currently available online.