Welcome to Flyin' Miata!

Redline lightweight Shockproof gear oil

Redline lightweight Shockproof gear oil
Redline lightweight Shockproof gear oil
$20.49
Make your transmission shockproof.

Made in the USA

Availability: In stock

Description

Details

For maximum gearbox protection. This is some odd stuff that adheres really well to gear teeth and cushions them against high pressures. This reduces the odds of stripped teeth. It has a film thickness like a 75W140, but the viscosity of an 80W.

For best results, we recommend mixing it 50-50 with Redline MTL or MT-90. Do not use if you have a transmission cooler.

Very cool blue color.

Additional Information

Additional Information

Part number 10-26040
TÜV approval available No
Fits: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), MSM, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Manufacturer No
Flyin' Miata exclusive No
Fits Exocet? Yes
Proposition 65 Warning: Cancer and reproductive harm
California emissions No information at this time
Reviews

Customer Reviews 4 item(s)

Overrated
Better than stock fluid, but this and Redline's MTL don't compare to Motorcraft Manual Transmission fluid. That's the best fluid I've used in my Miata so far and has reduced the grinding/notchiness of my transmission more than any other fluid.
Rating
Review by Ian / (Posted on 10/25/2018)
Great stuff'
Redline MTF the synchronizer crunch when shifting from 2nd to 3rd gears in my 1997 Miata. I' very please with the MTF despite despite the higher cost
Rating
Review by Chip / (Posted on 12/8/2016)
Useful for noise reduction in Mazda 5 speed gear box . . .
Yesterday, I changed to half Lightweight Shockproof (LWSP) and half MT90, on my 1,600cc Miata and drove the car for a few hours over the Angeles Crest and into the lightly traveled, winding roads with hairpin turns, which descend from the San Gabriel Mountains into western Mohave Desert. In still air deserts are quiet places, and you can really hear what is going on with the car. My experience is that with LWSP the gear box is a lot quieter, and this comes at the cost of slightly increased shifting effort.

The NA6 (1,600cc) engine has a lighter fly wheel than the NA8 (1,800cc), which makes the gearbox more subject to gear roll-over clatter. Both versions of the car have this noise which is pronounced when on engine braking. On the NA6 it is worst. Flywheels mitigate the firing pulses of the engine, averaging them out before those pulses reach the gear box The lighter the fly wheel, the more the pulses come through. Our Miata gear boxes started life as Asian market light pickup truck engines. Bob Hall, one of the originators of the Miata concept, worked on the B series pickups, and would have known that gearbox well. These 5 speeds were also used on the RX7s.

In the US this transmission was imported in the B2000 half-ton pickup. These are quite sturdy gear boxes, with very loose tolerances, in the gear to gear spacing. Therefore, for lubrication they will accept just about anything. The engine firing pulses, with a light flywheel, coming into the input shaft can and do cause the un-driven gears on the counter shaft to go into resonance with their mating pairs on the output shaft. And this creates a lot of clatter, which is an unpleasant noise in a car with as little sound proofing as the NA Miata. Generally 'better' gear boxes in passenger cars do not have this clatter. So it sounds like a 'cheap' gear box, which it is not. It is, however, basically a truck transmission, and with trucks designers are little concerned about noise. Lastly, the repeated impact of this roll-over clatter has to have some effect in work hardening the gear faces. For those of use who drive in the mountains we are engine braking about half the time, and that is when the roll-over clatter is worst. So there are a number of reasons to want that noise gone.

Heavier oils limit gear roll-over noise, however they also increase shifting effort. With their greater film thickness, they dampen impact between the gear teeth. I had been using half Redline MT90 and half Redline 75W140, which helps with this gear clatter, but does not eliminate it. The LWSP proof has an unusually high film thickness, and so it goes still further in damping impact in during the resonance of gear roll-over. With half and half LWSP and MT90 some of the clatter is still there, but overall, gear box noise has been reduced below the level of the MT90/75W140 mixture.

At this point I have LWSP in the differential, and 50/50 in the transmission, and all the running gear is quieter.

I like this LWSP stuff.
Rating
Review by Maneki Neko / (Posted on 7/3/2015)
Great for the NA6 differential. Has anyone used this in an MX5 Five Speed Transmission?
The NA6 Miata has a somewhat undersized differential, with a 6" ring gear. The size and capacity of the differential was increased in 1994 to 7" with the NA8. So the NA6 differential has long held to be vulnerable to damage. This is an excellent product for the NA6 differential. The differential will run more quietly. You will notice this from the cabin of the car. There is no down side.

What I would like to know is if anyone has used this in our 5 speed gear box for any significant period of time. I would be especially interested to know if this has been used in a Mazda five speed, if that five speed had been torn down after 6 months or so of use.

Apparently the very fine, solid lubricant additive can clog some kinds of bearings in assemblies where there is insufficient flow of the oil to keep the fine powder in suspension. The resulting clogging which occurs can prevent fresh oil from reaching all the bearing of the assembly, leading to lubrication starvation and failure. Has anyone used LW Shock Proof in a tracked Miata for six months or so, and then torn then box down after the fact? It would be very helpful to hear of such a result and to see photographs.

Note from Flyin' Miata: We’ve been mixing it in equal parts with MTL for years in high HP applications with no apparent adverse effects. We haven’t had to tear down a gearbox that’s had it in it.
Rating
Review by Maneki Neko / (Posted on 6/28/2015)
Instructions
Instructions for this part are not currently available online.