USPS shipments from our warehouse may be slightly delayed. Details

Welcome to Flyin' Miata!

NA one-piece dual gauge pod

One piece dual gauge pod
NA one-piece dual gauge pod
An OE-looking replacement trim panel with mounting points for two gauges.

Availability: In stock

Description

Details

Most of our gauge pods slip over top of the stock trim. They're held in place with fasteners and there's a visible seam between the stock part and the pod. Not with these - this is a full replacement for the stock interior trim and uses factory fasteners. It looks as if the factory intended the gauges to be there. Fits all NA Miatas.

Holds two 2 1/16" gauges - also known as 2".

Additional Information

Additional Information

Part number M21-16570 1990-97
TÜV approval available No
Fits: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997
Manufacturer No
Flyin' Miata exclusive No
Fits Exocet? No
Proposition 65 Warning: Cancer and reproductive harm
California emissions No information at this time
Reviews

Customer Reviews 2 item(s)

Very Clean Look
This gauge pod setup fit into the car like stock, and I didn't have to trim the gauge pod slots to fit the boost or wideband.
The only small complaint I have is, theres no way to drill the center screw for this when your gauges are already in. On the flipside, you CAN screw the A'pillar in place, but then you cant put your bottom gauge in.

moral of the story is, install your gauges first, and then firm up the A'pillar to the stock contact points, and lastly drill and screw for the top hole. that should be plenty of assurance that A'pillar isnt going to rattle around.
Rating
Review by Reisce / (Posted on 4/30/2020)
Okay
I purchased recently for my aem uego 2 1/16 gauge and 52mm boost gauge neither of them fit without modification
Rating
Review by Miataboost09 / (Posted on 10/13/2019)
Instructions
Instructions for this part are not currently available online.