Make bleeding your brakes easy! Speed Bleeders replace your original bleed screw and let you service your brakes without the need for a helper.
How do you use them? Just crack them loose, attach a hose, and pump away. An internal check valve will let fluid and air escape but won't let any air back into the system. When you're done, just snug them up again.
Sold in pairs. Stock calipers use one Speed Bleeder, so you'll need one pair for each end of the car. Wilwood and ND Brembo calipers use two per caliper, so you will need one pair for each corner. The exception is the current six-piston Dynapro 6A, which has only one bleeder. Please look at your calipers if you are unsure.
Note that the ND slave cylinder uses a completely different style of bleeder and no Speed Bleeder will work with it.
NA/NB/NC front stock calipers, M8x1.0 thread
NA/NB rear stock calipers, M7x1.0 thread
ND front stock calipers (Brembo and stock), M10x1.0 thread
NC/ND rear stock calipers, M8x1.25 thread
Wilwood caliper (front or rear), 1/4-28 thread
NA/NB/NC clutch slave cylinders use the NA/NB rear stock caliper bleeders, M7x1.0 thread
|Designed for:||1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), 2004-05 MSM, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 MX-5, 2017 MX-5 soft top, 2017 MX-5 RF, 2017 Fiat 124 Spider, 2018 MX-5 soft top, 2018 MX-5 RF, 2018 Fiat 124 Spider, 2019 MX-5 soft top, 2019 MX-5 RF, 2019 Fiat 124 Spider, 2020 MX-5 soft top, 2020 MX-5 RF, 2020 Fiat 124 Spider, 2021 MX-5 soft top, 2021 MX-5 RF|
|California emissions||Emissions regulations do not apply|
|Proposition 65||Not applicable|
|Flyin' Miata exclusive||No|