Polyurethane exhaust hanger (NB and NC chassis, extended length)

$9.79
IN Stock
Part number
M06-97350 LONG
Get your exhaust system under control and replace your droopy vintage rubber hangers.

Is your exhaust droopy? Do you have clanks and clunks under your car? The exhaust on your Miata is held up by 4-5 rubber hangers - and they're probably as old as your Miata. Make your exhaust all perky again with these polyurethane hangers. They're stiffer than the originals, so your exhaust will stay in place no matter how hard you drive. Great for cars with big exhausts and tight clearances. We think a lot of butterfly braces would fit better with a few of these.

This extended length one is approximately 1" longer than the original design. It works well to install a non-Mazdaspeed FM exhaust on a Mazdaspeed Miata.

Sold individually. Suitable for NB and NC. 4 needed on NB models, 5 for NC. 12mm holes.

More Information
Part number M06-97350 LONG
Designed for: 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), 2004-05 MSM, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Fits Exocet? Information not available
California emissions Emissions regulations do not apply
Manufacturer Flyin' Miata
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive No
Write Your Own Review
You're reviewing:Polyurethane exhaust hanger (NB and NC chassis, extended length)
Your Rating
© Flyin' Miata. All Rights Reserved.