Blueprinted front wheel hub (NA/NB chassis)

As low as $219.00
SOME OPTIONS IN STOCK
Part number
16-10010
Blueprinted front hub - stop hub failures! Now including nuts.

If you're running your NA or NB Miata hard on the track, you're probably burning through front wheel bearings on a regular basis. And that means you're losing track time or races. ART knows this, so they've put together these blueprinted hubs. They start off as factory hubs, but they're carefully checked and packed with a high temperature grease. They'll cut down your failure rate dramatically.

Sure, they're a bit more expensive. But they'll last a whole lot longer than stock ones, so you'll save money in the long run.

Available either with stock studs or with strong extended ARP units. If you go for the ARP units, you will need to press them into the hubs.

These hubs are not compatible with ABS rings, so you will lose your ABS. Sold individually. Nuts are included, but new dust caps are recommended.

Recommended installation is to have everything very clean, install and torque to 145 ft-lbs with a proper torque wrench, not power tools.

Sold individually - that's one hub.

More Information
Part number 16-10010
Designed for: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), 2004-05 MSM
Fits Exocet? Yes
Instructions Click here
California emissions Emissions regulations do not apply
Manufacturer Flyin' Miata
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive No
Write Your Own Review
You're reviewing:Blueprinted front wheel hub (NA/NB chassis)
Your Rating
© Flyin' Miata. All Rights Reserved.