Flyin' Miata 1990-05 shock tower brace

Ships for free!
Rating:
98% of 100
$249.00
Out of stock
Part number
13-26020 1990-05
Finally, a well-designed shock tower brace for the Miata. Now fits all NA and NB models!

Cars with strut suspensions rely on the top of the strut towers to maintain their suspension geometry - and inconveniently, there's usually an engine between them in the front. So strut tower braces are very popular to improve the handling on those cars.

But a Miata has a double wishbone front suspension. The top of the shock tower is mostly taking vertical loads. But there's still a big hole in the middle of the engine bay, and that means the structure of the car suffers in this area. Joining the shock towers together with a well-designed brace will improve steering feel and cut down on cowl shake when you hit a bump.

Of course, the brace has to be designed properly. There are a lot of cheap ones that are simply shiny jewelery for the engine bay. The cross bars are very flexible, there's usually a bolt in just the wrong place that acts as a pivot and the towers are flimsy. Some also "triangulate" to the thin metal at the top of the firewall, but there's no structure to tie into there.

Mazda knows this. It's why, when they designed the brace found on many 2001-05 Miatas, they put two vertical bolts on each side with a nearly-straight bar in the middle on top of beefy towers. And it's why our bar is designed along similar lines. Ours, however, will fit under the hood of a 1990-97 model as well as the later cars.

We didn't just stop with the design, though. We made the parts out of High Strength Low Alloy steel, which gives more strength for the same weight. This makes the brace even more effective. The bars are finished in wrinkle-coat powdercoat.

Fits:
1990-05 four cylinder with most turbochargers and superchargers. This includes all of our current turbocharger kits. Mazdaspeed Miatas will require re-plumbing the crankcase ventilation system and (if equipped with our Enchilada intake) modifying the air filter mount. The stock brace is pretty good on those cars, so we recommend against using our brace on an MSM unless you are prepared to do some fabricating.

Does not fit:
air intakes that sit on top of the shock tower, such as Racing Beat
M45 superchargers
LS engines with an insulated intake manifold, although you can remove the insulation

More Information
Part number 13-26020 1990-05
Fits model year: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), MSM
Fits Exocet? No
California emissions No information at this time
Manufacturer Paco Motorsports
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive Yes
Write Your Own Review
You're reviewing:Flyin' Miata 1990-05 shock tower brace
Your Rating
© Flyin' Miata. All Rights Reserved.