Flyin' Miata NC four piston rear brake upgrade

As low as $899.00
In Stock
Part number
I14-16670
The rear half of our four wheel Little Big Brake Kit, this will let you upgrade any NC brake setup.

There are a number of Wilwood front big brake kits on the market. But only one that addresses the rear of the car.

In the rear, we used the same exclusive Powerlite rear caliper that we've also used on earlier Miatas. This stiff little aluminum four-piston caliper includes a parking brake mechanism, so you're not sacrificing anything. The caliper is 1.75 lbs lighter (each!) than the stock caliper. In order to fit the caliper, we had to change to a slightly larger 11.9" rear rotor - stock is 11.5". It's originally from a Mazda5, so replacements are easy to source from Flyin' Miata or elsewhere.

The Powerlite rear caliper has been modified to use the factory handbrake cables, even factory clips so it's a really clean install. The handbrake is not as powerful as the stock setup, so while it can be used to hold the car on a moderate grade, it is not suitable for initiating handbrake turns.

The rear brakes fit under stock 17" wheels. We have not tested it with stock 16" setups. Please note that the stainless steel brake lines included with the kit are not the same as the ones used with stock calipers.

Templates to check clearance!
Rear

The kit includes:
Stainless steel brake lines
Wilwood Powerlite handbrake rear calipers with BP-10 pads
new rear rotors

More Information
Part number I14-16670
Designed for: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Fits Exocet? No
Instructions Click here
California emissions No information at this time
Manufacturer Flyin' Miata
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive Yes
Write Your Own Review
You're reviewing:Flyin' Miata NC four piston rear brake upgrade
Your Rating
© Flyin' Miata. All Rights Reserved.