Flyin' Miata Cannon rear subframe brace

Ships for free!
Rating:
96% of 100
$139.00
ON BACKORDER, ETA May 03, 2021
Part number
13-69000
Stiffen up that rear end!

This is a big burly brace machined out of 1/4" aluminum and powdercoated black. It ties together both lower rear control arm mounting points, and triangulates them to the subframe to prevent any possibility of shifting under side loads. The factory brace isn't triangulated - if the car even has one! Similar braces on the market are generally made of thin steel and aren't strong enough to handle the load without flexing. Exclusive to Flyin' Miata!

Exhaust removal not required for installation.

Fits 1990-91 and 1999-05 Miatas, including the 2004-05 Mazdaspeed. You can mount it on a 1992-97, but you'll have to cut off a bracket for the stock brace.
May have conflict with JR exhaust.

While this will work with our Paco eccentric locks, bear in mind that the Cannon brace will have to be removed everytime you do an alignment. So it's possible, but it will be a bit of a headache. If you don't have the Paco eccentric locks, it does NOT need to be removed to perform an alignment. 

More Information
Part number 13-69000
Designed for model year: 1990, 1991, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), 2004-05 MSM
Fits Exocet? Yes
Instructions Click here
California emissions Emissions regulations do not apply
Manufacturer Flyin' Miata
Proposition 65 Warning: Cancer and reproductive harm
Flyin' Miata exclusive Yes
Write Your Own Review
You're reviewing:Flyin' Miata Cannon rear subframe brace
Your Rating
© Flyin' Miata. All Rights Reserved.