USPS shipments from our warehouse may be slightly delayed. Details

Welcome to Flyin' Miata!

Ball joint boot installation tool

Ball joint not included.
Ball joint boot installation tool
Don't cut your brand new ball joint boots!

Made in the USA

Exclusive to Flyin' Miata

Availability:
Ball joint boot installation tool (Moog for NA): 7 in stock

Description

Details

Good boots are critical to the lifespan of your ball joints. The problem is that most people don't have the correct tool to install them.

You could use a socket, but that will likely cause splits in the boot. If you have a piece of pipe, it has to be just the right diameter and a burr will ruin your day.

Fear no more! These tools are made of carbon fiber reinforced nylon to do this job perfectly. They're the perfect diameter with a radiused inside edge to avoid pinching the rubber and slicing it. You simply grease up the interior of the boot, slip it into place and slide this tool on top. Then use a nut on the threaded shaft to press the boot into place. It'll bottom out on the stud when you're done. Perfect installation.

Currently only available for the NA replacement Moog ball joints, but we will soon have them for other applications.

Additional Information

Additional Information

Part number 35-6400x
TÜV approval available No
Fits: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), MSM, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 MX-5 soft top, 2017 MX-5 soft top, 2017 MX-5 RF, 2017 Fiat 124 Spider, 2018 MX-5 soft top, 2018 MX-5 RF, 2018 Fiat 124 Spider, 2019 MX-5 soft top, 2019 MX-5 RF, 2019 Fiat 124 Spider, 2020 MX-5 soft top, 2020 MX-5 RF, 2020 Fiat 124 Spider
Manufacturer Flyin' Miata
Flyin' Miata exclusive Yes
Fits Exocet? Yes
Proposition 65 Warning: Cancer and reproductive harm
California emissions Emissions regulations do not apply
Reviews
Instructions
Instructions for this part are not currently available online.

* Required Fields