Paco Motorsports Hub Stand Kit v5.1
Paco Motorsports Hub Stand Kit v5.1
SKU
SKU
Instructions
Instructions
Data
Data
Fits: Universal
Emissions: Emissions do not apply.
Shipping restrictions: None
Warranty: 1 year
Share
What are hub stands? They bolt on to your hubs in place of your wheels so you have full access to the suspension while the car is on the ground. They also sit on steel balls so they can move around and take any preload out of the suspension. This makes it easy to corner-weight the car and tighten up suspension bolts.
But wait, there's more! The stands are also designed to make it easy to align the car yourself. Toe and camber are dead simple, while caster and even thrust angle are straightforward. You can turn the adjusters and watch the settings change. You will need a pair of tape measures and some way to measure camber - either a smartphone or our digital gauge.
That's right, you'll never pay for an alignment again. We use these at the FM shop all the time, even if it's just to set the bushings after a suspension install.
Fits the following:
ALL MIATAS ...and.... all 4 bolt patterns ranging from 4 x 95.25 to 4 x 114.3 (that's 4 x 3.75" to 4 x 4.5") on cars using 12mm studs. all 5 bolt patterns ranging from 5 x 100 to 5 x 130mm on cars using 12mm studs maximum hub diameter of 72.5 mm cars up to 4000 lbs.
Sold as a complete set of four including thrust alignment cables. If your garage floor is cracked - or perfect and you don't want to risk any potential lines in your epoxy from the steel balls - be sure to pick up a set of floor plates.
Since these are kinda big and bulky, they can be... annoying... to store. Check out Paco Motorsport's hanger kit (above) to get them up and out of the way!