Replacement front upper control arms for NB


On Backorder

Part number

Because you can't replace just the ball joint, unfortunately.

Customize Replacement front upper control arms for NB
1 x Replacement front upper control arm for NB, right   + $69.99 (backorder, more expected Apr 29, 2021)

* Required Fields

Your Customization
Replacement front upper control arms for NB
Replacement front upper control arms for NB

In stock



    The NB front upper control arm contains a ball joint that was not designed to be replaceable. Unfortunately, there is no aftermarket replacement ball joint that is designed specifically for the different taper used in the NB upright. This means that if you have a bad ball joint, you have to change out the whole arm.

    You can tell if your upper ball joint is bad if you get a hard thump under braking or sudden cornering loads. Also, the ball joint should have some resistance to movement and not just flop around. Failure usually starts with a damaged boot that allows debris into the joint.

    Cars that use NB uprights should use an NB upper control arm. Cars with NA uprights will need an arm with an NA ball joint.

    This is a Moog aftermarket replacement part. It includes new rubber bushings as well as the ball joint. Ready to bolt in.

    While this part is not adjustable for alignment, we do recommend getting your alignment checked after installation just in case.

    More Information

    More Information
    Part number M13-8211X
    Designed for: 1999, 2000, 2001, 2002, 2003, 2004 (non-MSM), 2005 (non-MSM), 2004-05 MSM
    Fits Exocet? Yes
    California emissions Emissions regulations do not apply
    Proposition 65 Warning: Cancer and reproductive harm
    Flyin' Miata exclusive No


    Write Your Own Review
    You're reviewing:Replacement front upper control arms for NB
    Your Rating
    © Flyin' Miata. All Rights Reserved.